Welcome to Xdrivers
Please login or register.

Author Topic: Problem with my 3.0sd  (Read 327 times)

0 Members and 1 Guest are viewing this topic.

May 21, 2018, 10:58:15 PM

jagr

  • Member
  • ***
  • Posts: 391
  • Country: gb
  • Location: Cheshire
  • Gender: Male
    • View Profile
Problem with my 3.0sd
« on: May 21, 2018, 10:58:15 PM »
Hi All,

I have developed a problem with my X3.
A few weeks ago while driving at around 55-60mph I went to overtake and the car just felt flat and failed to accelerate. I presumed the MAP sensor and running Carly seemed to agree.
I first tried cleaning with electrical contact cleaner and it seemed better so bought a new one last week. A couple of days later it happened again so checked vac pipes which all seemed ok (I did replace them with silicon a couple of years ago). Again diverter valves were changed for the newer model early last year for preventative maintenance.

Tonight it happened again and this is the freeze frame from Carly for the error:

*** 3F01:Boost pressure sensor signal ***
 Fault-Set 1 - ( 101984 km)

     Air mass per cylinder: 283.57 mg/Hub
     ambient pressure: 994.46 mbar
     battery voltage: 14.01 V
     Boost pressure actual value: 364.31 mbar
     Coolant temperature: 92.29 deg C
     Engine speed: 1489.45 1/min
     Injection quantity: 7.88 mg/Hub
     Rail Pressure Is: 346.58 bar
     vehicle speed: 50.34 km/h
     Voltage boost pressure sensor: 21.65 mV

 Fault-Set 2 - ( 101984 km)

     Air mass per cylinder: 460.01 mg/Hub
     ambient pressure: 994.46 mbar
     battery voltage: 14.01 V
     Boost pressure actual value: 393.85 mbar
     Coolant temperature: 89.28 deg C
     Engine speed: 1323.96 1/min
     Injection quantity: 18.12 mg/Hub
     Rail Pressure Is: 425.35 bar
     vehicle speed: 32.57 km/h
     Voltage boost pressure sensor: 21.65 mV

Any ideas?

Cheers
Current Vehicles:
2007 BMW X3 3.0sd M Sport 286bhp
2005 Porsche Boxster 2.7

May 24, 2018, 08:42:02 PM
Reply #1

marti

  • Member
  • ***
  • Posts: 155
  • Country: gb
    • View Profile
Re: Problem with my 3.0sd
« Reply #1 on: May 24, 2018, 08:42:02 PM »
You've answered your own question....new MAP sensor required or you have a vacuum leak

May 31, 2018, 01:59:02 PM
Reply #2

Evokid007

  • Newbie
  • *
  • Posts: 5
  • Country: gb
    • View Profile
Re: Problem with my 3.0sd
« Reply #2 on: May 31, 2018, 01:59:02 PM »
Mine had a similar issue and I replaced Air flow meter . Can’t remember fault codes off hand though.